Flagstaff Welding Machine Square Flagpole Welder Use SAW / MAG
Welding Method Light Pole Longitudinal Seam Welder
Machine Main Components :
- Long working table with rack for pull doly.
- Dolly for pulling pole
- Hydraulic clamping and welding unit (including 3 sets clamping
- polygonal and circle pole)
- Submerged Arc Welding and Gas-shielded welding(CO2) Welding system,
- including welding wire feeding system.
- The flux recovering system
- back support unit
- hydraulic system
Machine Introduction :
Light pole shut and welding machine mainly use for combining the
steel joint and welding its longitudinal seam . We had exported many this type machine to all over the world. As a
specially in producing the pole clamping and welding machine. We
have lots of experience in producing this machine.The pole was
widely used in the city and road. It is suitable for one piece type
polygonal and circle taper light pole. It is an automatic welding
line, the dolly with speed adjustable motor can pull (or push) the
light pole from small end to big end , The hydraulic cylinder
through mechanical chain, Worm wheel push the clamping wheel to
close the pole and do welding at the same time.
Suitable light pole Thickness base
on mild steel Q235
Light pole diameter: 60~450mm
Light pole diameter: 70~450mm
Light pole diameter: 250~450mm
Power of Motor for Pump
Power of Motor for pulling dolly
4 KW, AC speed changeable type.
630A, (Submerged Arc Welding and
Gas-shielded welding(CO2) Welding
Welding wire diameter
1.2,1.6~2mm welding wire, according the pole
thickness to do selection
1.1~2m/min (Note: different thickness speed
will be different )
Overall sizes (mm)
22000x2000x2000 mm (LXWXH)
Lincoln welding machine (USA BRAND)
Note:, If chose the Lincoln welding machine,normally it is suitable
for Submerged Arc Welding
Fast motorized return back for dolly
Note:for the standard machine, the dolly return back can be
motorized with working speed, it
is very slow for return back process. So, normally, the operator
will open the dolly clutch and
push the dolly by manual.
In order to reduce the manpower, we have option: Fast motorized
return back for dolly. The
operator only push button, the dolly will be back to the welding
See attached detail photos.
Both Side additional hydraulic cylinder
It is suitable for small diameter big thickness light pole, or
steel plate with high tensile
strength light pole.
With this additional option , the diameter from 60~450mm, thickness
2.8~6mm, all pole can be
suitable. And easy for operation.
Electricity pole and lamp pole was widely used in the countryside
and City ,such as electricity transport pipe , shine lamp pole ;
blinker , Offshore,Petro Chemical ; Plate Heat Exchanger ; Charged
air cooler ; Pressure Vessel ;Pipe system&Steel works etc.
1. All the bolt using 12.9 grade Bolt , not using 8.4 grade. Making
the machine more stronger.
2. 20 % overweight design , could making the rotator focus more.
3. Double row wheels ,not only making the wheels stable, but also
artifacts to increase friction.
4. All the parts using well-known brands in China or other
countries . Quality is more reliable .
5. Using double row bearings.
6. The base of rotator welded by plates, with high strength, no
deformation after long time using.